Technics sx-PR804/M, sx-PR604/M Assigning the images, Picture List, Loading your original images

Part IV Sequencer

Assigning the images

Assign images to the selected point (PIC) of a song.

1.Use the SONG SELECT ∧ and ∨ of the SEQUENCER MENU display to select a song number to which the images will be assigned, and select RECORD & EDIT.

2.Select STEP RECORD on the RECORD & EDIT display.

3.Use the balance buttons below the display to

select CONTROL TRACK (CTL).

•The display looks similar to the following.

4.Use the MEAS ∧ and ∨ buttons to specify the measure to assign.

5.Use the CURSOR buttons to move the cursor (reversed box) to the point you are going to

assign an image.

•Each point represents one-eighth of a quarter note ( a thirty-second note).

6.Press the PIC button.

•The display looks similar to the following.

7.Use the PRESET/USER button to select one.

PRESET: preset images

USER:

your original images loaded beforehand

8.Use the VALUE button to select the image number.

9.Press the YES button.

•The image of the specified number is assigned to that point (PIC).

10.Repeat the steps 4 to 9 to continue assigning.

11.When you have finished assigning, press the

PROGRAM MENUS button to turn it off.

•When you play back the song, the images appear on the display and change automatically corresponding to the music progression (Slide Show).

•The moment where the images are displayed may be retarded slightly from the specified point. If this is too excessive, adjust the point so that it occurs slightly sooner.

•When two assigned points are too close, the result may not be favorable. It is recommended that the interval between two points should not be less than two beats for a =120 tempo music for example.

•The preset images are not compatible with other models.

PICTURE LIST

On the step 3 display, if you press the PICTURE button, a list of USER image data will be displayed.

•Press the RENAME button to rename the image data name.

•Press the DEL button to delete selected image data.

Loading your original images

1.Save the image data to a disk using your PC. etc.

2.Insert the disk with saved data into the DISK DRIVE. (See page 96.)

3.On the CONTROL display of the STEP RE- CORD, press the PICTURE button.

4.On the PICTURE LIST display, press the PIC-

TURE LOAD button.

•The display looks similar to the following.

5.Select the image data file to be loaded.

•When you select a image sized over 640 x 240 pixels, press the TRIMMING button to select the type of data cutting out.

6.Use the USER PICTURE ∧ and ∨ buttons to specify the image number to which the image data will be loaded.

7.Press the LOAD button.

•The image is loaded and “COMPLETED!” is shown on the display.

Sequencer

73

QQTG0665