Composer

Part V

Composer

Step Record

Use STEP RECORD to store the notes one-by-one on the display. This is a convenient way to store complicated patterns that are difficult to play.

Recording procedure

1.While you are recording, press the STEP RE-

CORD button.

The display changes to the STEP RECORD display similar to the following.

6.Repeat steps 2 through 5 to continue storing

notes.

To record a different part, use the PART and buttons to select another part.

PAGE 1/2: The NOTE, VEL(OCITY), LEN(GTH), CHORD MODIFY and CONTROL can be revised later. Move the cursor to select the data you wish to revise, correct the value, and then press the OK button.

You can easily switch between the REALTIME mode and the STEP mode any time during recording. To return to the realtime recording display during the STEP RECORD mode, press the EXIT button.

2.Use the CURSOR buttons to move the cursor

to the note position you are going to store.

Each dot represents one-eighth of a quarter-note (a thirty- second note).

When storing triplets, it may not be possible to match the timing exactly with the 1/32-note steps. However, if you select triplet-type notes for the note length (LENGTH) in step 4 below, the timing is automatically corrected.

3.Use the left LENGTH buttons to specify the note value you are going to store next. Select

from 3, , 3, , 3, , 3, , , , 2 to 4.

(A 3 denotes a triplet-type note.)

For note values other than these, use the right LENGTH buttons to specify the note value to be added to that which you specified with the left buttons.

Example: To record a dotted quarter-note ( .)

+

4.Use the PHRS and buttons to specify the actual length of the produced sound for the desired legato or staccato effect.

TENU (tenuto):

Sound is produced for 95% of the

 

note length.

NORM (normal):

80%

STAC (staccato):

50%

CUTT (cutting):

25%

 

 

5.Specify the pitch and velocity of the note by

playing the keyboard.

The dot on the display where the note is stored changes to a * mark.

When recording chords, you can store multiple notes at one position.

REST:

To store a rest, after specifying the note LENGTH,

press the REST button.

Positions at which nothing is stored are read as rests. ERS:

If you make a mistake, move the cursor to the error, and after displaying the data you wish to erase, press the ERS button.

90

QQTG0665

Page 90
Image 90
Technics sx-PR604/M While you are recording, press the Step RE Cord button, Repeat steps 2 through 5 to continue storing