Part I

Sounds and effects

2. Use the and buttons to select an effect

CHORUS

group.

Add breadth to the sound. This effect can be set for each

The EFFECT MEMORY is for edited effects (see below).

part.

 

Sounds and effects

3.Use the buttons to the right of the display to

select the type.

If the types comprise more than one display “page,” use the PAGE buttons to switch pages.

If you press the VARI button to turn it ON, the effect variation is selected.

This display can also be accessed from the REVERB & EFFECT MENU display. (Refer to page 109.)

EFFECT EDIT

The effects can be edited and then stored in a memory.

1.Select an effect type to use as a base.

2.Press the EFFECT EDIT button.

The display changes to the following.

3.Use the PARAMETER and buttons to

select the parameter.

The parameters vary depending on the effect type selected as the base.

(V) indicates a parameter for the VARIATION.

4.Use the VALUE and buttons to adjust the setting.

5.Press the EFFECT NAMING button and assign

a name to the effect, if necessary.

Refer to page 55 for details about the NAMING procedure.

6.Use the EFFECT MEMORY LIST and buttons to specify the location in which to store the edited effect.

7.Press the WRITE button.

1.Select the sound to which the effect will be applied.

2.Press the CHORUS button to turn it on.

CHORUS

The on or off status of the CHORUS is preset for each sound.

Type and parameter settings

1.Press and hold the CHORUS button for a few

seconds.

The display looks similar to the following.

2.Use the and buttons to select an effect

group.

The EFFECT MEMORY is for edited effects (see below).

3.Use the buttons to the right of the display to

select the type.

If the types comprise more than one display “page,” use the PAGE buttons to switch pages.

This display can also be accessed from the REVERB & EFFECT display. (Refer to page 109.)

EFFECT EDIT

Your edited effect can be stored in a memory for later recall.

The procedure is the same as for MULTI EFFECT.

DIGITAL EFFECT

DIGITAL EFFECT gives the sound richness and enhances your performance. This effect can be set for each part.

1.Select the sound to which the effect will be applied.

2.Press the DIGITAL EFFECT button to turn it on.

DIGITAL EFFECT

The on or off status of the DIGITAL EFFECT is preset for each sound.

This effect may not work for some sounds.

If a DRAWBAR sound is not selected for a performance part, and if the MULTI EFFECT is off for all parts, the nuance of this effect in the RIGHT 1 part and other parts will differ.

40

QQTG0665

Page 40
Image 40
Technics sx-PR604/M, sx-PR804/M operating instructions Chorus, Digital Effect, Effect Edit