TDS2CMA Communications Module
138 TDS1000/2000-Series Digital Oscilloscope User Manual
CH 1
PROBECOMP
6. On the oscilloscope,push UTILITY "Options "RS-232.
7. Check that the menu settings match thoselisted in the table on
page 137.
8. From your PC terminal program, type ID?, then press the Return
or Enter key to send the command. The oscilloscope sends back
its identification string, which should l ook similarto the
following:
ID TEK/TDS 1002,CF:91.1CT,FV:V1.09 TDS2CMA:CMV:V1.04
If you do not get any response, refer to the troubleshooti ng steps
that start on page 139.
9. Send the command FACtory to reset the oscilloscope to factory
settings (defaults).