Appendix A: Specifications
TDS1000/2000-Series Digital Oscilloscope User Manual 165P2200 Probe Specifications
Electrical
characteristics
10X position 1X position
Bandwidth DC to 200 MHz DCto 6 MHz
Attenuation ratio 10:1 ±2% 1:1 ±2%
Compensation
Range
18 pf-35 pf Compensation is fixed; correct for
all oscilloscopes with 1 M Ωinput
Input Resistance 10 M Ω±3% at DC 1MΩ±3% at DC
Input Capacitance 14.5pf-17.5 pf 80 pf-110 pf
Rise time, typical <2.2ns <50.0 ns
Maximum input
voltage1
10X position 300 VRMS CAT I or 300 V DC CAT I
300 VRMS CAT II or 300 V DC CAT II
100 VRMS CAT III or 100 V DC CAT III
420 V peak, <50% DF,<1 s PW
670 V peak, <20% DF,<1 s PW
1X position 150 VRMS CAT I or 150 V DC CAT I
150 VRMS CAT II or 150 V DC CAT II
100 VRMS CAT III or 100 V DC CAT III
210 V peak, <50% DF,<1 s PW
330 V peak, <20% DF,<1 s PW
300 VRMS, Installation Category II; derate at 20 dB/decade above
900 kHz to 13 V peak AC at 3 MHz and above. For non-sinusoidal
waveforms, peak value mustbe less than 450 V. Excursion above 300
V should be less than 100 msduration. RMS signal level including
any DC component removed through AC coupling mustbe limite d to
300 V.If these values are exceeded, damage to the instrument may
result. Refer to the Overvoltage Category on the next page.
1As defined in EN61010-1 on the next page.