TDS2CMA Communications Module
144 TDS1000/2000-Series Digital Oscilloscope User Manual
HConnect the oscilloscope to the GPIBnetwork. Use an appropri-
ate GPIB cable. You can stack cable connectors. The next table
lists cables that you can order to conne ct the oscilloscopeto the
GPIB network.
Cable type Tektronix part number
GPIB, 6.6 feet (2 meters) 012-0991-00
GPIB, 3.3 feet (1 meter) 012-0991-01
HAssign a uniquedevice address to the oscilloscope.No two
devices can share the same device address. The GPIB Setti ngs
information describeshow to set the oscilloscope GPIB interface.
HPower on at least two-thirds of the GPIB devices while using the
network.
GPIB Settings
To set theoscilloscope GPIB interface, followthese steps:
1. If you have not done so yet, connect the oscilloscope to the GPIB
network.