Getting Started
TDS1000/2000-Series Digital Oscilloscope User Manual 5
Functional Check
Perform this quick functional check t o verify that your oscilloscope
is operating correctly.
PASSED
ON
/
OFF
button
1. Power on the oscilloscope.
Wait until the displayshows that all
power-on tests passed. Push the DEFAULT
SETUP button. The default Probe option
attenuation setting is 10X.
CH 1
PROBECOMP 2. Set the switch to 10X on the P2200 probe
and connect the probe to channel 1 on the
oscilloscope. To do this, align the slot in
the probe connector with the key on the
CH 1 BNC, push to connect, and twist to
the right to lock the probe in place.
Connect the probe tip and reference lead
to the PROBE COMP connectors.
3. Push the AUTOSET button. Withina few
seconds, you should see a square wave in
the display of about 5 V peak-to-peak at
1kHz.
Push the CH 1 MENUbutton twice to
remove channel 1, push the CH 2 MENU
button to display channel 2, repea t steps 2
and 3. For 4-channel models, repeat for
CH 3 and CH 4.