Manuals / Toshiba / Household Appliance / Air Conditioner

Toshiba RAS-M14EAV-E, RAS-M13EKCVP-E 88, <Primary check>, Troubleshooting for remote controller

Models: RAS-B10EKVP-E RAS-M14EAV-E RAS-B13EKVP-E RAS-M18EAV-E RAS-M10EKCVP-E RAS-M16EKCVP-E RAS-M14EACV-E RAS-M18EACV-E RAS-M13EKCVP-E

1 136

Download 136 pages 38.01 Kb

Page 88

(5) Troubleshooting for remote controller

(5) Troubleshooting for remote controller

<Primary check>

Check that A or B selected on the main unit is matched with A or B selected on the remote controller.

The unit does not beep at all.

Push the START/STOP button. OPERATION indicator on

indoor unit is not lit.

NO

Is transmission

mark indicated?

YES

Is receiver

NO

Push RESET button

on indoor unit

on remote controller

exposed to

with tip of pencil.

direct sunlight?

YES

Does indoor unit

Is there any

NO

NO

operate when moving

thyristor

fluorescent light

remote controller

near receiver or

nearby?

indoor unit?

YES

YES

Batteries are

exhausted.

Push the START/

STOP button

NO

Does indoor unit

start to operate by

automatic restart

Is transmission

NO

function?

mark indicated?

YES

YES

NO

Does indoor unit

beep and operate?

Does radio sound

YES

is affected by remote

NO

controller when a signal is

transmitted at distance of

5 cm from radio?

YES

P.C. board

Remote controller

is defective.

is defective.

Keep indoor unit

Avoid direct

away from thyristor

Replace

Replace

Normal

Replace

sunlight.

fluorescent light.

P.C. board.

batteries.

operation

remote controller.

NOTE : After replacing batteries, push the RESET button with a tip of a pencil.

– 88 –

Image 88

Toshiba RAS-M14EAV-E, RAS-M13EKCVP-E, RAS-M18EACV-E, RAS-M18EAV-E 88, <Primary check>, Troubleshooting for remote controller

Contents

SPLIT TYPE AIR-CONDITIONERFILE NO. A04-015 CONTENTS For general public use 1. SAFETY PRECAUTIONSDANGER For Reference – 4 –2. SPECIFICATIONS Table of models that can be connectedTable of models that can be used in combination – 5 –– 6 – Page Cooling Indoor: DB/WB=27/19C Outdoor: DB=35C – 8 –Heating Indoor: DB=20C Outdoor: DB/WB=7/6C <Cooling> RAS-M18EAV-E , RAS-M18EACV-E – 9 –<Heating>RAS-M18EAV-E 2-2-1.Operation Characteristic Curve – 10 –<Cooling> RAS-M14EAV-E, RAS-M14EACV-E RAS-M14EAV-E, RAS-M14EACV-E <Cooling>2-2-3.Operation Characteristic Curve – 11 –<Cooling> RAS-M18EAV-E, RAS-M18EACV-E RAS-M18EAV-E, RAS-M18EACV-E3-1.Safety During Installation/Servicing 3-2.Refrigerant Piping Installation3. REFRIGERANT R410A 3-2-1.Piping Materials and Joints Used3-2-2.Processing of Piping Materials – 13 –– 14 – – 15 – 3-3.Tools 3-3-1.Required ToolsGeneral tools Conventional tools can be used – 16 –3-4.Recharging of Refrigerant – 17 –3-5.Brazing of Pipes 3-5-1.Materials for Brazing3-5-2.Flux – 18 –Never use gas other than Nitrogen gas 3-5-3.Brazing– 19 – 4. CONSTRUCTION VIEWS 4-1.Indoor Unit– 20 – RAS-B10EKVP-E RAS-B13EKVP-E RAS-B16EKVP-E4-2.Outdoor Unit – 21 –5. WIRING DIAGRAM 5-1.Indoor UnitT3.15A – 22 –5-2.Outdoor Unit – 23 –Specifications – 24 –RAS-B16EKVP-E, RAS-B13EKVP-E, RAS-B10EKVP-E RAS-M16EKCVP-E, RAS-M13EKCVP-E, RAS-M10EKCVP-E6-2.Outdoor Unit – 25 –Parts name Model name7. REFRIGERANT CYCLE DIAGRAM 7-1.Refrigerant Cycle Diagram– 26 – RAS-B13EKVP-E, RAS-B10EKVP-E RAS-M14EAV-ERAS-M13EKCVP-E, RAS-M10EKCVP-ERAS- M14EACV-E Page – 29 – 7-2.Operation Data – 30 –8. CONTROL BLOCK DIAGRAM REMOTE CONTROLLER8-1.Indoor Unit – 31 –REMOTE CONTROLLER RAS-M10EKCVP-E, RAS-M13EKCVP-E, RAS-M16EKCVP-ECONTROL BLOK DIAGRAM Outdoor unit – 33 –M.C.U M.C.U9-1.Outline of Air Conditioner Control 9. OPERATION DESCRIPTION– 34 – 9-2.Operation Description ContentsPage Page – 37 – – 38 – Ts +Ts – Fan only operation Cooling-onlymodelSymbols – 39 –Item Operation flow and applicable data, etc– 40 – Operation flow and applicable data, etcDescription <In heating operation> Heat pump modeloutdoor temperatureTo and – 41 –Item Operation flow and applicable data, etc– 42 – – 43 – – 44 – ItemOperation flow and applicable data, etc <In cooling/dry operation>– 45 – ItemOperation flow and applicable data, etc Description– 46 – ItemOperation flow and applicable data, etc Description– 47 – ItemOperation flow and applicable data, etc DescriptionOperation flow and applicable data, etc – 48 –Description – 49 – 1. Purpose 2. Description3. Operation 1. PurposeOperation flow and applicable data, etc – 51 –Description Clean operation – 52 –Item Operation flow and applicable data, etcSetting the clean operation Outline diagram of P.C. board– 53 – ItemSetting the remote controller Setting the selector switch on the main unit– 54 – Item9-3.Auto Restart Function 9-3-1.How to Set the Auto Restart Function– 55 – 9-4.FILTER Indicator 9-3-2.How to Cancel the Auto Restart Function9-3-3.Power Failure During Timer Operation 9-4-1.How to Turn Off FILTER Indicator9-5-1.Parts Name of Remote Controller 9-5.Remote Controller and Its Fuctions– 57 – Display – 58 –adbhj Hi-POWERbutton on the remote controller is pushed 9-6. Hi-POWERMode– 59 – 10. INSTALLATION PROCEDURE Optional Installation Parts Accessory and Installation Parts10-2.OptionalParts, Accesories and Tools – 61 –Installation/Service Tools – 62 –10-3.Installation of Indoor Unit Installation LocationDrilling a Hole and Mounting Installation Plate – 63 –Electrical Work – 64 –Wiring Connection – 65 –Piping and Drain Hose Installation – 66 –– 67 – In case of right or left pipingIn case of bottom right or bottom left piping Left-handconnection with pipingDrainage Indoor Unit Installation– 68 – NOTES Table of models that can be used in combination– 69 – 10-5-1.Installation Location 10-5.Installation of Outdoor Unit– 70 – Draining the water – 71 –10-5-2.Refrigerant Piping Connection – 72 –10-5-3.Evacuating – 73 –10-5-4.Wiring Connection – 74 –Miswiring Mis-pipingCheck 10-6.Grounding10-7.Check and Test Operation – 75 –Auto Restart Setting Remote Control Selector Switch Setting10-8.TestOperation Gas Leak Test Test OperationSelf-Diagnosisby LED Indication 10-9.USEFUL FUNCTIONS– 77 – 11. HOW TO DIAGNOSE THE TROUBLE – 78 –– 79 – < Discharging method >11-1-1.Confirmation of Power Supply 11-1-2.Confirmation of Power Voltage11-1.First Confirmation – 80 –11-2.Primary Judgment 11-3.Judgment by Flashing LED of Indoor Unit– 81 – NOTES– 82 – 11-4-2.Caution at Servicing – 83 –– 84 – Block distinctionOperation of diagnosis function Judgment and action11-5.Judgment of Trouble by Every Symptom 11-5-1.Indoor Unit Including Remote Controller<Confirmation procedure> – 85 –Primary check – 86 –3 Only the indoor motor fan does not operate <Inspection procedure> <Cause>– 88 – 5 Troubleshooting for remote controller<Primary check> – 89 – 1Outdoor unit does not operate<Check procedure> – 90 –11-7.Trouble Diagnosis by Outdoor LED – 91 –11-7.Troubleshooting How to check output of the air purifier– 92 – <Caution on High Voltage!!>Primary check – 93 –Operation check Diagnosis/Process flowchart Contents– 94 – Item11-9-1.How to Check the P.C. Board Indoor Unit 11-9.How to Check Simply the Main Parts– 95 – 3 Check procedures Table Procedure– 96 – Check points11-9-2.P.C. Board Layout 1 Sensor characteristic table– 97 – 11-9-4.Outdoor Unit 11-9-3.Indoor Unit Other Parts– 98 – 11-9-5.Checking Method for Each Part + ~ ~– 99 – – 100 – 1.Symptom2. Cause 12. HOW TO REPLACE THE MAIN PARTS 12-1Indoor Unit – 101 –Procedures installation plate<How to assemble the front panel> 102– 103 – – 104 – ProceduresNo. Part name – 105 – – 106 – 107 108 Procedures – 109 –No. Part name Cross flow <Caution at reassembling>12-2 Microcomputer– 110 – P.C. board layout12-3.Outdoor Unit – 111 –Procedures 112Part name Detachment113 – 114 – Procedures – 115 –Part name Remarks– 116 – – 117 – Procedures – 118 –Part name Remarks– 119 – Remarks– 120 – Outdoor unit main PCB MCC-5009– 121 – Outdoor unit Sub PCB MCC-500913-1.Indoor Unit 13. EXPLODED VIEWS AND PARTS LIST– 122 – – 123 – 13-2.Outdoor Unit – 124 –13-3.P.C. Board Layout 125Cord Heater Installation Work Specifications/VendorAppendix Appendix-1Specifications/Vendor SpecificationsAppendix Appendix-2Appendix 3. Cord heater installation wiring diagramAppendix-3 4. Cord heater installation work procedure Photo / Explanatory diagramProcedure AppendixPhoto / Explanatory diagram ProcedureAppendix Appendix-5Photo / Explanatory diagram ProcedureAppendix Appendix-6Photo / Explanatory diagram ProcedureAppendix Appendix-7Photo / Explanatory diagram ProcedureAssembly AppendixAppendix 5. Drawing of thermostat fixing plate8 5.8 11 28 11 18Appendix Appendix-10