Toshiba RAS-M14EACV-E, RAS-M13EKCVP-E, RAS-M18EACV-E, RAS-M16EKCVP-E Wiring Connection, 74

Packed valve handling precautions

•Open the valve stem all the way; but do not try to open it beyond the stopper. Securely tighten the valve stem cap with torque in the following table:

Gas side	50 to 62 N·m
(φ12.7 mm)	(5.0 to 6.2 kgf·m)
Gas side	33 to 42 N·m
(φ9.52 mm)	(3.3 to 4.2 kgf·m)
Liquid side	14 to 18 N·m
(φ6.35 mm)	(1.4 to 1.8 kgf·m)
Service port	14 to 18 N·m
	(1.4 to 1.8 kgf·m)

Hexagon wrench is required.

4 mm

10-5-4. Wiring Connection

1.Remove the valve cover, the electric parts cover and the cord clamp from the outdoor unit.

2.Connect the connecting cable to the terminal as identified by the matching numbers on the terminal block of indoor and outdoor unit.

3.Insert the power cord and the connecting cable fully into the terminal block and secure it tightly with screws.

4.Insulate the unused cords (conductors) from water entering in the outdoor unit. Locate them so that they do not touch any electrical or metal parts.

5.Secure the power cord and the connecting cable with the cord clamp.

6.Attach the electric parts cover and the valve cover on the outdoor unit.

Stripping length of connecting cable

Terminal block

1 2 3 1 2 3 L N

	1 2 3	L N	10
		10
	10
40	10		40
	30	30

						Power cord	Earth line
			Earth line		Connecting
Connecting		Power cord
	Connecting				cable
cable for unit A
	cable for unit B
Model		RAS-M14EAV-E		RAS-M18EAV-E		RAS-M14EACV-E	RAS-M18EACV-E
Power source					220–240V	~50Hz
					220V	~60Hz
Maximum running current		10.0A			15.0A	8.0A	11.0A
Installation fuse rating					25A (D type	)
Power cord				H07RN-F or 245IEC66 (1.5 mm2 or more)
Connecting cable				H07RN-F or 245IEC66 (1.0 mm2 or more)

CAUTION

•Incorrect wiring connection may cause electrical parts to burn out.

•Be sure to comply with local regulations/codes when running the wire from outdoor unit to indoor unit. (Size of wire and wiring method etc.)

•Every wire must be securely connected.

•This installation fuse (25A D type ) must be used for the power supply line.

•If incorrect or incomplete wiring is carried out, fire or smoke may result.

•Prepare the power supply for the exclusive use of the air conditioner.

•This product can be connected to the main breaker.

Connection to fixed wiring: A switch which disconnects all poles and has a contact separation of at least 3 mm must be incorporated in the fixed wiring when connecting to a main breaker circuit.

– 74 –