Toshiba RAS-M18EAV-E, RAS-M13EKCVP-E, RAS-M18EACV-E, RAS-M14EACV-E, RAS-M16EKCVP-E, RAS-B13EKVP-E 113

No. Part name		Procedure	Remarks
# Inverter	1)	Perform work of item 1 in !.	Inverter cover
assembly	2)	Remove screw (ST1TØ4 x 8l 2 pcs.) of the upper	P. C. board
		part of the front cabinet.	(Soldered surface)

•If removing the inverter cover in this condition, P.C. board can be checked.

• If there is no space above the unit, perform work of 1 in ".

Be careful to check the inverter because high-voltage circuit is incorporated in it.

		Discharging position	Plug of
3) Perform discharging by connecting ,	polarity		soldering
		(Discharging period
			iron
by discharging resistance (approx. 100Ω40W) or		10 seconds or more)

plug of soldering iron to , terminals a of the C14 (printed “CAUTION HIGH VOLTAGE” is at- tached.) electrolytic capacitor (760µF) on P.C. board.

		Be careful to discharge the capacitor be-
		cause the electrolytic capacitor cannot
		naturally discharge and voltage remains	A screw
		according to trouble type in some cases.	(STIT-4X8MSZN)
		NOTE :
		This capacitor is one with mass capacity.
		Therefore, it is dangerous that a large spark
		generates if short-circuiting between ,
		polarity with screwdriver, etc. for discharging.
4)	Remove screw (ST1TØ4 x 8l 2 pcs.) fixing the
	main body and the inverter box.		Put the compressor	Put each leads
5) Remove the front cabinet by performing step 1 in			leads and the comp. through the
	", and remove the fixing screws (ST1TØ4 x 8 l )		thermo leads	slit.
			through the hole.
	for securing the main body and inverter box.
6) Remove various lead wires from the holder at			The connector is
	upper part of the inverter box.		one with lock,
7)	Pull the inverter box upward.		so remove it while
8)	Disconnect connectors of various lead wires.		pushing the part
			indicated by an
			arrow.
		Requirement :
		As each connector has a lock mechanism,
		avoid to remove the connector by holding
		the lead wire, but by holding the connector.

Be sure to remove the connector by holding the connector, not by pulling the lead wire.

– 113 –