Configuration: Passthrough

Global Settings

the online help for the encoder. You can also control devices using VBrick's VBIR remote controller. To use the VBIR remote controller, you connect the VBIR SpitFire device to COM1 or COM2 on the VBrick encoder. The VBIR subsequently communicates with the DVD or VCR via infrared commands (see Figure 9) at the configured baud rate.

If necessary, connect one end of the XIR emitter cable to the SpitFire and the other to the DVD or VCR making sure the adhesive lead is securely attached to the device. The emitter is used when there is no direct line-of-sight to a control device (for example when the VCR is in a cabinet) and you can't use the remote control. On the back of the VBIR, be sure the SpitFire is in RS-232 mode.

Figure 9. Connecting Control Devices

Table 10. Device Connectors

Device

Connector

 

 

VCR

DB-9

 

 

DVD

DB-15

 

 

MPEG-1 Encoder

DB-9

 

 

MPEG-2/4/WM Encoders

RJ-45

 

 

Typical device connector.

Configuring Control Devices

You also need to configure the baud rate and passthrough state of the VBrick associated with

a control device. In IWS, go to thepage and set these values as follows:

Table 11. Baud Rate and Passthrough State

Device

Baud Rate

Passthrough State

 

 

 

DVD

4800

Responder

 

 

 

VCR

9600

Responder

 

 

 

VBIR

2400

N/A

 

 

 

ETV Portal Server Admin Guide

43

Page 55
Image 55
VBrick Systems ETV v4.2.1 manual Configuring Control Devices, Device Connector, Device Baud Rate Passthrough State