Xantrex Technology ENET-XFR3 Command Summary, AUXACommand, 3 Programming Commands, TM-XR9B-01XN

Operation

Command Summary

Use these commands to control the operation of the supply. They are listed here in order of function such as PROGRAMMING, QUERY, CALIBRATION, and STATUS commands. See “Command Reference” on page 3–9for more detailed information about each command and its use.

Table 3-3Programming Commands

AUXACommand	DescriptionSelects the state of the AUXA output signal on the Pin 7 of the
	user lines connector.
AUXB	Selects the state of the AUXB output signal on the Pin 8 of the
	user lines connector.
CLR	Initializes the power supply to its Power ON (PON) state.
DLY	Sets a programmable time delay which is executed by the supply
	before reporting fault conditions after a new output voltage or
	current is specified.
GTL	Sends the supply to local mode.
FOLD	Sets foldback mode for the supply.
HOLD	Enables or disables voltage/current setting hold mode for the
	supply.
IMAX	Sets an upper soft limit on the programmed output current for the
	supply.
ISET	Sets the output current of the supply in amps (default) or in
	milliamps.
LLO	Local Lockout. Disables the front panel LOCAL button.
OUT	Enables or disables voltage/current output for the supply.
OVSET	Sets the over voltage protection trip point for the supply in volts
	(default) or in millivolts.
REN	Sets remote mode or local mode.
RST	Resets the supply to the present voltage and current settings if the
	output is disabled by OVP or foldback protection.
TRG	Implements programmed voltage and current settings which had
	been in hold mode.
VMAX	Sets an upper soft limit on the supply’s programmed output
	voltage.
VSET	Sets the output voltage of the power supply in volts (default) or in
	millivolts.

3–6 TM-XR9B-01XN