Operation
Table 3-10 Ethernet Mode Tips
SymptomAble connect to the device server
(Ethernet Bridge), but unable to control r receive a response from the power supply
PossibleCauses | Corrective Actions | |
The Eth | Reconfigure the interface card for Ethernet | |
Interface card is configured | c | mmun cations. See page |
for |
|
|
The embedded Ethernet | Ensure that the baud rate for the Ethernet Bridge | |
Bridge is incorr ctly | is set for 9600 by connecting to its HTTP server | |
c nfigur d | and checking its Serial Port settings. This can be | |
| d | ne by entering the device's IP address into a |
| web brows r and using the correct username and | |
| password to ac ess the device server. See | |
| “Configuring Ether et Bridge” on page | |
| m | information. |
| Ensure hat the baud rate setting on the interface | |
| card is set to 9600 - ee the “Baud Rate | |
| Selection” on page | |
|
|
|
