Xantrex Technology ENET-XFR3 manual Configuration, Introduction

2	Installation and
	Configuration

Introduction

The Ethernet/RS-232 Interface is usually installed at the factory. Your local distributor or service center can also install the interface, especially for use in a previously-purchased supply already on site. You must then configure the Interface-enhanced supply for your system using the “Basic Setup Procedure - Ethernet” on page 2–10, or the “Basic Setup Procedure - RS-232” on page 2–11.

To use this product, you must have the following equipment:

•a Xantrex XFR DC output power supply

•computer-based communications software package