CONFIGURING THE SWITCH

Web – Click Security, Port Security. Set the action to take when an invalid address is detected on a port, mark the checkbox in the Status column to enable security for a port, set the maximum number of MAC addresses allowed on a port, and click Apply.

Figure 3-22. Configuring Port Security

CLI – This example sets the command mode to Port 5, sets the port security action to send a trap and disable the port, and then enables port security for the switch.

Console(config)#interface ethernet 1/5

 

Console(config-if)#port security action trap-and-shutdown

3-102

Console(config-if)#port security

 

Console(config-if)#

 

 

 

3-50

Page 98
Image 98
SMC Networks SMC8624/48T manual Configuring Port Security