SMC Networks SMC8624/48T manual 280, Ip igmp snooping query-max-response-time

MULTICAST FILTERING COMMANDS

Command Mode

Global Configuration

Example

The following shows how to configure the query interval to 100 seconds.

Console(config)#ip igmp snooping query-interval 100

Console(config)#

ip igmp snooping query-max-response-time

This command configures the query report delay. Use the no form to restore the default.

Syntax

ip igmp snooping query-max-response-time seconds no ip igmp snooping query-max-response-time

seconds - The report delay advertised in IGMP queries. (Range: 5-30)

Default Setting

10 seconds

Command Mode

Global Configuration

Command Usage

•The switch must be using IGMPv2 for this command to take effect.

•This command defines the time after a query, during which a response is expected from a multicast client. If a querier has sent a number of queries defined by the ip igmp snooping query-count, but a client has not responded, a countdown timer is started using an initial value set by this command. If the countdown finishes, and the client still has not responded, then that client is considered to have left the multicast group.

4-280