SMC Networks SMC8624/48T manual Line Commands, Line Command Syntax

COMMAND LINE INTERFACE

The access mode shown in the following tables is indicated by these abbreviations:

NE (Normal Exec)	IC (Interface Configuration)
PE (Privileged Exec)	LC (Line Configuration)
GC (Global Configuration)	VC (VLAN Database Configuration)
ACL (Access Control List	MST (Multiple Spanning Tree)
Configuration)

Line Commands

You can access the onboard configuration program by attaching a VT100 compatible device to the server’s serial port. These commands are used to set communication parameters for the serial port or Telnet (i.e., a virtual terminal).

Table 4-5. Line Command Syntax

Command	Function	Mode	Page
line	Identifies a specific line for configuration and	GC	4-15
	starts the line configuration mode
login	Enables password checking at login	LC	4-16
password	Specifies a password on a line	LC	4-17
exec-timeout	Sets the interval that the command interpreter	LC	4-18
	waits until user input is detected
password-thresh	Sets the password intrusion threshold, which	LC	4-19
	limits the number of failed logon attempts
silent-time*	Sets the amount of time the management	LC	4-20
	console is inaccessible after the number of
	unsuccessful logon attempts exceeds the
	threshold set by the password-thresh
	command
databits*	Sets the number of data bits per character that	LC	4-21
	are interpreted and generated by hardware
parity*	Defines the generation of a parity bit	LC	4-22
speed*	Sets the terminal baud rate	LC	4-23

* These commands only apply to the serial port.

4-14