COMMAND LINE INTERFACE

stopbits

This command sets the number of the stop bits transmitted per byte. Use the no form to restore the default setting.

Syntax

stopbits {1 2}

1 - One stop bit

2 - Two stop bits

Default Setting

1 stop bit

Command Mode

Line Configuration

Example

To specify 2 stop bits, enter this command:

Console(config-line)#stopbits 2

Console(config-line)#

disconnect

Use this command to terminate an SSH, Telnet, or console connection.

Syntax

disconnect session-id

session-id– The session identifier for an SSH, Telnet or console connection. (Range: 0-4)

Command Mode

Privileged Exec

Command Usage

Specifying session identifier “0” will disconnect the console connection. Specifying any other identifiers for an active session will disconnect an SSH or Telnet connection.

4-24

Page 268
Image 268
SMC Networks SMC8624/48T manual Syntax Stopbits 1, Syntax Disconnect session-id