COMMAND LINE INTERFACE

Example

The following shows LACP enabled on ports 11-13. Because LACP has also been enabled on the ports at the other end of the links, the show interfaces status port-channel 1 command shows that Trunk1 has been established.

Console(config)#interface ethernet 1/11 Console(config-if)#lacp Console(config-if)#exit Console(config)#interface ethernet 1/12 Console(config-if)#lacp Console(config-if)#exit Console(config)#interface ethernet 1/13 Console(config-if)#lacp Console(config-if)#exit Console(config)#exit

Console#show interfaces status port-channel 1 Information of Trunk 1

Basic information:

Port type: 1000T

Mac address: 00-00-e8-00-00-0b Configuration:

Name:

Port admin status: Up

Speed-duplex: Auto

Capabilities: 10half, 10full, 100half, 100full, 1000full,

Flow control status: Disabled

Port security: Disabled

Max MAC count: 0 Current status:

Created by: lacp

Link status: Up

Operation speed-duplex: 1000full

Flow control type: None

Member Ports: Eth1/11, Eth1/12, Eth1/13, Console#

4-191

Page 436
Image 436
SMC Networks SMC8624/48T manual 191