COMMAND LINE INTERFACE

Command Usage

This command displays the currently configured source port, destination port, and mirror mode (i.e., RX, TX, RX/TX).

Example

The following shows mirroring configured from port 6 to port 11.

Console(config)#interface ethernet 1/11 Console(config-if)#port monitor ethernet 1/6 Console(config-if)#end

Console#show port monitor Port Mirroring

-------------------------------------

Destination port(listen port):Eth1/1

Source port(monitored port)

:Eth1/6

Mode

:RX/TX

Console#

 

Rate Limit Commands

This function allows the network manager to control the maximum rate for traffic transmitted or received on an interface. Rate limiting is configured on interfaces at the edge of a network to limit traffic into or out of the network. Traffic that falls within the rate limit is transmitted, while packets that exceed the acceptable amount of traffic are dropped.

Rate limiting can be applied to individual ports or trunks. When an interface is configured with this feature, the traffic rate will be monitored by the hardware to verify conformity. Non-conforming traffic is dropped, conforming traffic is forwarded without any changes.

Table 4-34. Rate Limit Commands

Command

Function

Mode

Page

rate-limit

Configures the maximum input or output

IC

4-186

 

rate for a port

 

 

 

 

 

 

4-185

Page 430
Image 430
SMC Networks SMC8624/48T manual Rate Limit Commands, Following shows mirroring configured from port 6 to port