SMC Networks SMC8624/48T manual IP Interface Commands, Basic IP Configuration, 284

IP INTERFACE COMMANDS

Example

The following shows that port 11 in VLAN 1 is attached to a multicast router.

Console#show ip igmp snooping mrouter vlan 1 VLAN M'cast Router Ports Type

---- ------------------- -------

1Eth 1/11 Static

2Eth 1/12 Dynamic

Console#

IP Interface Commands

There are no IP addresses assigned to this switch by default. You must manually configure a new address to manage the switch over your network or to connect the switch to existing IP subnets. You may also need to a establish a default gateway between this device and management stations or other devices that exist on another network segment.

Basic IP Configuration

Table 4-52. Basic IP Configuration commands

Command	Function	Mode	Page
ip address	Sets the IP address for the current	IC	4-285
	interface
ip dhcp restart	Submits a BOOTP or DCHP client	PE	4-286
	request
ip default-gateway	Defines the default gateway through	GC	4-286
	which this switch can reach other
	subnetworks
show ip interface	Displays the IP settings for this device	PE	4-288
show ip redirects	Displays the default gateway configured	PE	4-288
	for this device
ping	Sends ICMP echo request packets to	NE,	4-289
	another node on the network	PE

4-284