COMMAND LINE INTERFACE

Example

The following creates protocol group 1, and specifies Ethernet frames with IP and ARP protocol types.

Console(config)#protocol-vlan protocol-group 1 add frame_type ethernet protocol-type ip

Console(config)#protocol-vlan protocol-group 1 add frame_type ethernet protocol-type arp

Console(config)#

protocol-vlan protocol-group (Configuring Interfaces)

This command maps a protocol group to a VLAN for the current interface. Use the no form to remove the protocol mapping for this interface.

Syntax

protocol-vlan protocol-group group-idvlan vlan-idno protocol-vlan protocol-group group-idvlan

group-id- Group identifier of this protocol group. (Range: 1-2147483647)

vlan-id- VLAN to which matching protocol traffic is forwarded. (Range: 1-4094)

Default Setting

No protocol groups are mapped for any interface.

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

When creating a protocol-based VLAN, only assign interfaces via this command. If you assign interfaces using any of the other VLAN commands (such as vlan on page -233),these interfaces will admit traffic of any protocol type into the associated VLAN.

4-245

Page 490
Image 490
SMC Networks SMC8624/48T manual 245, Protocol-vlan protocol-group Configuring Interfaces