SMC Networks SMC8624/48T manual Setting an IP Address, Manual Configuration

INITIAL CONFIGURATION

Type “username admin password 0 password,” for the Privileged Exec level, where password is your new password. Press <Enter>.

Username: admin

Password:

CLI session is opened.

To end the CLI session, enter [Exit].

Console#configure

Console(config)#username guest password 0 [password]

Console(config)#username admin password 0 [password]

Console(config)#

Setting an IP Address

You must establish IP address information for the switch to obtain management access through the network. This can be done in either of the following ways:

Manual — You have to input the information, including IP address and subnet mask. If your management station is not in the same IP subnet as the switch, you will also need to specify the default gateway router.

Dynamic — The switch sends IP configuration requests to BOOTP or DHCP address allocation servers on the network.

Manual Configuration

You can manually assign an IP address to the switch. You may also need to specify a default gateway that resides between this device and management stations on another network segment. Valid IP addresses consist of four decimal numbers, 0 to 255, separated by periods. Anything outside this format will not be accepted by the CLI program.

Note: The IP address for this switch is unassigned by default.

2-6