Korg KORG Pa50 user manual Er/Delay, Early Refl, AutoReverse

202Effects

ER/Delay

ER/DELAY

Early reflection and delay effects

041: Early Refl

(Early Reflections)

This effect is only the early reflection part of a reverberation sound, and adds presence to the sound. You can select one of the four decay curves.

Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left		Wet / Dry
EQ Trim
LEQ	HEQ
+	Pre Delay	Early Reflections
EQ Trim
Right		Wet / Dry

a	Type	Sharp, Loose, Modulated, Reverse
	Selects the decay curve for the early reflection			☞
b	ER Time [msec]			10...800msec
	Sets the time length of early reflection
c	Pre Delay [msec]			0...200msec
	Sets the time taken from the original sound to the first early reflection
d	EQ Trim		0...100
	Sets the input level of EQ applied to the effect sound
	Pre LEQ Gain [dB]			–15.0...+15.0dB
e	Table , “Sets the gain of Low EQ,” on page 176
	Pre HEQ Gain [dB]			–15.0...+15.0dB
	Table , “Sets the gain of High EQ,” on page 176
	Wet/Dry		Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
f	Src			Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt			–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175

a: Type

This parameter selects the decay curve for the early reflec- tion.

Early Reflections - Type

Sharp

Loose

Modulated

Reverse

Dry
	Pre Delay	ER Time

042: AutoReverse

(Auto Reverse)

This effect records the input signal and automatically plays it in reverse (the effect is similar to a tape reverse sound).

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left			Wet / Dry
+		Auto Reverse	Direct
			Mix
		Rec/Reverse Play
		Control
Right			Wet / Dry
D-mod	D-mod
		Envelope Control
	Input
	Envelope Select

a	Rec Mode				Single, Multi
	Sets the recording mode						☞
b	Reverse Time [msec]		20...1320msec
	Sets the maximum duration of the reverse playback					☞
	Envelope Select			D-mod, Input
	Selects whether the start and end of recording is controlled via the modula-
c	tion source or the input signal level			☞ ,
	Src			Off...Tempo
	Selects the modulation source that controls recording when Envelope
	Select is set to D-mod					☞
	Threshold			0...100
d	Sets the recording start level when Envelope Select is set to Input
						☞
e	Response			0...100
	Sets the speed of the response to the end of recording			☞ Fx:031
f	Direct Mix	Always On, Always Off, Cross Fade
	Selects how a dry sound is mixed			☞ Fx:031
	Wet/Dry	Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
g	Src			Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt				–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175

a: Rec Mode, b: Reverse Time

When ”Rec Mode“ is set to Single, you can set up to 1320msec for “Reverse Time. ”If recording starts during the reverse playback, the playback will be interrupted.

When “Rec Mode” is set to Multi, you can make another recording during the reverse playback. However, the max- imum Reverse Time is limited to 660msec.

If you wish to record a phrase or rhythm pattern, set “Rec Mode” to Single. If you record only one note, set “Rec Mode” to Multi.

The “Reverse Time” parameter specifies the maximum duration of the reverse playback. The part in excess of this limit will not be played in reverse. If you wish to add short pieces of the reverse playback of single notes, make the “Reverse Time” shorter.

			Rec Mode/Reverse Time
Rec	Reverse Rec	Reverse	Envelope Select = Input

Input

Time

Rec Mode = Single

Rec Mode = Multi

Reverse Time Reverse Time