238

Error messages & Troubleshooting

Troubleshooting

TROUBLESHOOTING

Problem

Solution

 

 

General problems

Page

Power does not turn on

Make sure that (1) the power cable is plugged into the outlet, (2) the cable is plugged

 

 

into the connector on the back of the instrument, (3) and is not damaged, (4) there are

 

 

no problems with the mains.

 

 

 

 

 

Is the power switch turned ON?

 

 

 

 

 

If the power still does not turn on, contact your dealer or the nearest KORG Service Cen-

 

 

ter.

 

 

 

 

No sound

Is a jack connected to the HEADPHONES connector? This would disable the internal

22

 

speakers.

 

 

 

 

 

Check the connections of your amp or mixer.

22

 

 

 

 

Make sure that all the components of the amplifying system are turned on.

 

 

 

 

 

Are the MASTER VOLUME or ASSIGN.SLIDER sliders of the Pa50 set to a position other

13

 

than “0”?

 

 

 

 

 

Is the Local parameter set to Off? Turn it On.

127

 

 

 

 

Is the Speaker parameter set to Off? Turn it On.

125

 

 

 

 

Is the Attack parameter value too high? Set it to a lower value, to let the sound start

43

 

faster. Is the Volume parameter too low? Set it to a higher value.

45

 

 

 

Lowest note are not played

When the SPLIT button is lit up, the keyboard will be divided into the Lower part (low

24

 

notes, below the split point) and the Upper part (high notes, above the split point). Is the

 

 

Lower track muted? Unmute it.

 

 

 

 

Wrong sounds

Do the USER banks contain modified data? Load the appropriate data for the Song or the

133

 

Style you wish to playback.

 

 

 

 

 

Has one of the USER Drum Kits been modified? Load the appropriate Drum Kits.

133

 

 

 

 

Have the Styles or Performances been modified? Load the appropriate data (Styles or Per-

133

 

formances).

 

 

 

 

Sound does not stop

Make sure that the damper switch polarity parameter is set correctly.

126

 

 

 

The selected Style or Song can-

Make sure that the Clock parameter is set to Int. If you are using the MIDI Clock of

127

not start

another device, you must set the MIDI Clock parameter to MIDI, and make sure that the

 

 

external device transmits MIDI Clock data.

 

 

 

 

Does not respond to MIDI mes-

Make sure that all MIDI cables are connected correctly.

22

sages

 

 

Make sure that the external device is transmitting through MIDI channels enabled to

46

 

 

receive in the Pa50.

78

 

 

 

 

Make sure that the MIDI IN Filters of the Pa50 do not prevent the reception of messages.

129

 

 

 

Percussive instruments are not

Make sure that the Percussion and Drum Track is set to Drum Mode and the

46

played correctly

external device has not transposition applied.

78

 

 

 

Some “clicks” can be heard

This is part of the sound, and not a problem.

 

when playing a percussive

 

 

instrument

 

 

 

 

 

A background noise can be

The selected Performance, Style or STS recalled the effect “15 Analog Record”, simulating

 

heard after selecting a Perfor-

the noise of a old vinyl recording.

 

mance, Style or STS

 

 

 

 

 

Disk related problems

 

 

 

 

 

Cannot format a floppy disk

Are you using a 3.5 inch 2DD or 2HD floppy disk? You must use one of these types.

 

 

 

 

 

Is the disk inserted correctly?

130

 

 

 

 

Is the write protect tab of the disk in the protect position?

130

 

 

 

Cannot save data to a floppy

Is the disk formatted?

140

disk

 

 

Is the disk inserted correctly?

130

 

 

 

 

 

Is the write protect tab of the disk in the protect position?

130

 

 

 

Cannot load data from a floppy

Is the disk inserted correctly?

130

disk

 

 

Does the disk contain data compatible with the Pa50?

132

 

 

 

 

Page 240
Image 240
Korg KORG Pa50 user manual 238, Troubleshooting, Problem, General problems, Disk related problems