Korg KORG Pa50 060 4EqPhsrChFl, 061 Par4Eq-Phsr, Parametric 4-Band EQ Chorus/Flanger, Output Mode

060: 4EqPhsrChFl

(Parametric 4-Band EQ – Chorus/Flanger)

This effect combines a mono-type four-band parametric equalizer and a chorus/flanger.

Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left		Wet / Dry
Parametric 4Band EQ	Chorus/Flanger
+	Chorus/Flanger	Normal
Trim	+
		Output Mode
	–
		Wet Invert
	Feedback
	Cho/Flng Wet / Dry
Right		Wet / Dry
	LFO: Tri / Sine

a	[E] Trim			0...100
	Sets the parametric EQ input level
	[E] Band1 Cutoff [Hz]			20...1.00kHz
	Sets the center frequency of Band 1
b	Q			0.5...10.0
	Sets the bandwidth of Band 1			☞ Fx:006
	Gain [dB]			–18...+18dB
	Sets the gain of Band 1
	[E] Band2 Cutoff [Hz]			50...5.00kHz
	Sets the center frequency of Band 2
c	Q			0.5...10.0
	Sets the bandwidth of Band 2			☞ Fx:006
	Gain [dB]			–18...+18dB
	Sets the gain of Band 2
	[E] Band3 Cutoff [Hz]			300...10.00kHz
	Sets the center frequency for Band 3
d	Q			0.5...10.0
	Sets the bandwidth of Band 3			☞ Fx:006
	Gain [dB]			–18...+18dB
	Sets the gain of Band 3
	[E] Band4 Cutoff [Hz]			500...20.00kHz
	Sets the center frequency for Band 4
e	Q			0.5...10.0
	Sets the bandwidth of Band 4			☞ Fx:006
	Gain [dB]			–18...+18dB
	Sets the gain of Band 4
f	[F] Delay Time [msec]			0.0...50.0msec
	Sets the delay time
	[F] LFO Frequency [Hz]			0.02...20.00Hz
g	Sets the LFO speed
	LFO Waveform			Triangle, Sine
	Selects LFO Waveform
	[F] Depth			0...100
h	Sets the depth of LFO modulation
	Feedback			–100...+100
	Sets the feedback amount			☞ Fx:020
	[F] Cho/Flng Wet/Dry	–Wet...–2:98, Dry, 2:98...Wet
i	Sets the effect balance of the chorus/flanger		☞ Fx:010, 020
	Output Mode		Normal, Wet Invert
	Selects the output mode for the chorus/flanger			☞
	Wet/Dry		Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
j	Src			Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt			–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175

i: Output Mode

When Wet Invert is selected, the right channel phase of the chorus/flanger effect sound is inverted. This creates pseudo-stereo effects and adds spread.

Effects 211

Mono – Mono Chain

However, if a mono-input type effect is connected after this effect, the left and right sounds may cancel each other, eliminating the chorus/flanger effects.

061: Par4Eq-Phsr

(Parametric 4-Band EQ – Phaser)

This effect combines a mono-type four-band parametric equalizer and a phaser.

Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left		Wet / Dry
Parametric 4Band EQ	Phaser
+	Phaser	Normal
Trim	+
		Output Mode
	–	Wet Invert
	Resonance
	Phaser Wet / Dry
Right		Wet / Dry
	LFO: Tri / Sine

a	[E] Trim		0...100
	Sets the parametric EQ input level
	[E] Band1 Cutoff [Hz]		20...1.00kHz
	Sets the center frequency of Band 1
b	Q		0.5...10.0
	Sets the bandwidth of Band 1		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 1
	[E] Band2 Cutoff [Hz]		50...5.00kHz
	Sets the center frequency of Band 2
c	Q		0.5...10.0
	Sets the bandwidth of Band 2		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 2
	[E] Band3 Cutoff [Hz]		300...10.00kHz
	Sets the center frequency for Band 3
d	Q		0.5...10.0
	Sets the bandwidth of Band 3		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 3
	[E] Band4 Cutoff [Hz]		500...20.00kHz
	Sets the center frequency for Band 4
e	Q		0.5...10.0
	Sets the bandwidth of Band 4		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 4
	[P] LFO Frequency [Hz]		0.02...20.00Hz
f	Sets the LFO speed
	LFO Waveform		Triangle, Sine
	Selects LFO Waveform
g	[P] Manual		0...100
	Sets the frequency to which the effect is applied
	[P] Depth		0...100
h	Sets the depth of LFO modulation
	Resonance		–100...+100
	Sets the resonance amount		☞ Fx:023
	[P] Phaser Wet/Dry	–Wet...–2:98, Dry, 2:98...Wet
i	Sets the phaser effect balance	☞ Fx:010, 023
	Output Mode	Normal, Wet Invert
	Selects the phaser output mode		☞ Fx:060
	Wet/Dry	Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
j	Src		Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt		–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175