Korg KORG Pa50 user manual Detune, OSC Mode, Fixed Frequency Hz, Input Level Dmod %, d Src

198Effects

Mod./P.Shift

	Wet/Dry	Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
h	Src		Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt		–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175

a: Pre LPF

This parameter enables you to set the damping amount of the high range sound input to the ring modulator. If the input sound contains lots of harmonics, the effect may sound dirty. In this case, cut a certain amount of high range.

b: OSC Mode

This parameter determines whether or not the oscillator frequency follows the note number.

c: Fixed Frequency [Hz]

This parameter sets the oscillator frequency when “OSC Mode” is set to Fixed.

d: Note Offset, d: Note Fine

These parameters for the oscillator are used when “OSC Mode” is set to Note (Key Follow). The “Note Offset” sets the pitch difference from the original note in semitone steps. The “Note Fine” parameter fine-adjusts the pitch in cent steps. Matching the oscillator frequency with the note number produces a ring modulation effect in the correct key.

037: Detune

Using this effect, you can obtain a detune effect that offsets the pitch of the effect sound slightly from the pitch of the input signal. Compared to the chorus effect, a more natural sound thickness will be created.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left		Wet / Dry
	Input Level	High Damp
+	Detune	Delay
		Feedback
	Input Level
Right		Wet / Dry

	Pitch Shift [cent]	–100...+100cent
	Sets the pitch difference from the input signal
a	Src	Off...Tempo
	Selects the modulation source of the pitch shift
	Amt	–100...+100cent
	Sets the modulation amount of the pitch shift
b	Delay Time [msec]	0...1000msec
	Sets the delay time
	Feedback	–100...+100
c	Sets the feedback amount
	High Damp [%]	0...100%
	Sets the damping amount in the high range

Input Level Dmod [%]	–100...+100
Sets the modulation amount of the input level	☞ ,
d

	Src		Off...Tempo
	Selects the modulation source for the input level		☞
	Wet/Dry	Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
e	Src		Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt		–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175

d: Input Level Dmod [%], d: Src

This parameter sets the dynamic modulation of the input level.

Input Level
	x1.0	Amt= +50
		Amt= +100
Louder	x0.5
		Higher	D-mod
	Zero		Max

Input Level D-mod

Input Level
	x1.0	Amt= –50
		Amt= –100
Louder	x0.5
	Higher	D-mod
	Zero	Max