Korg KORG Pa50 Lim-Par.4Eq, Lim-ChorFlg, Limiter Parametric 4-Band EQ, Limiter Chorus/Flanger

216Effects

Mono – Mono Chain

070: Lim-Par.4Eq

(Limiter – Parametric 4-Band EQ)

This effect combines a mono-type limiter and a four-band parametric equalizer. You can change the order of the effect connection.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left			Wet / Dry
		Routing
	Limiter
		Parametric 4Band EQ
+	Limiter
	Gain Adjust	Trim
Right			Wet / Dry
	Envelope - Control
[L] Ratio			1.0:1...50.0:1, Inf:1
Sets the signal compression ratio			☞ Fx:003

a

	Threshold [dB]		–40...0dB
	Sets the level above which the compressor is applied		☞ Fx:003
	[L] Attack		1...100
b	Sets the attack time		☞ Fx:003
	Release		1...100
	Sets the release time		☞ Fx:003
c	[L] Gain Adjust [dB]		–Inf, –38...+24dB
	Sets the limiter output gain		☞ Fx:003
d	[E] Trim		0...100
	Sets the parametric EQ input level
	[E] Band1 Cutoff [Hz]		20...1.00kHz
	Sets the center frequency of Band 1
e	Q		0.5...10.0
	Sets the bandwidth of Band 1		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 1
	[E] Band2 Cutoff [Hz]		50...5.00kHz
	Sets the center frequency of Band 2
f	Q		0.5...10.0
	Sets the bandwidth of Band 2		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 2
	[E] Band3 Cutoff [Hz]		300...10.00kHz
	Sets the center frequency for Band 3
g	Q		0.5...10.0
	Sets the bandwidth of Band 3		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 3
	[E] Band4 Cutoff [Hz]		500...20.00kHz
	Sets the center frequency for Band 4
h	Q		0.5...10.0
	Sets the bandwidth of Band 4		☞ Fx:006
	Gain [dB]		–18...+18dB
	Sets the gain of Band 4
i	Routing	LMT→ PEQ, PEQ→ LMT
	Switches the order of the limiter and parametric EQ connection
	Wet/Dry	Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
j	Src		Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt		–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175

071: Lim-ChorFlg

(Limiter – Chorus/Flanger)

This effect combines a mono-type limiter and a chorus/ flanger. You can change the order of the effect connection.

Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left				Wet / Dry
	Routing
		Chorus/Flanger
	Limiter
+	Limiter	Chorus/Flanger		Normal
	EQ Trim LEQ HEQ		+
				Output Mode
	Gain Adjust
			–
		Feedback		Wet Invert
			Cho/Flng Wet / Dry
Right				Wet / Dry
	Envelope - Control	LFO: Tri / Sine

	[L] Ratio		1.0:1...50.0:1, Inf:1
a	Sets the signal compression ratio				☞ Fx:003
	Threshold [dB]				–40...0dB
	Sets the level above which the compressor is applied				☞ Fx:003
	[L] Attack				1...100
b	Sets the attack time				☞ Fx:003
	Release				1...100
	Sets the release time				☞ Fx:003
c	[L] Gain Adjust [dB]				–Inf, –38...+24dB
	Sets the limiter output gain				☞ Fx:003
	[F] LFO Frequency [Hz]				0.02...20.00Hz
d	Sets the LFO speed
	LFO Waveform				Triangle, Sine
	Selects LFO Waveform
	[F] Delay Time [msec]				0.0...50.0msec
	Sets the delay time
e	Depth				0...100
	Sets the depth of LFO modulation
	Feedback				–100...+100
	Sets the feedback amount				☞ Fx:020
f	[F] EQ Trim				0...100
	Table , “Sets the EQ input level,” on page 176
	[F] Pre LEQ Gain [dB]				–15...+15dB
g	Table , “Sets the gain of Low EQ,” on page 176
	Pre HEQ Gain [dB]				–15...+15dB
	Table , “Sets the gain of High EQ,” on page 176
	[F] Cho/Flng Wet/Dry	–Wet...–2:98, Dry, 2:98...Wet
h	Sets the effect balance of the chorus/flanger			☞ Fx:010, 020
	Output Mode		Normal, Wet Invert
	Selects the output mode for the chorus/flanger				☞ Fx:067
	Routing	LMT→	FLNG, FLNG→ LMT

iSwitches the order of the limiter and chorus/flanger connection

☞Fx:067

	Wet/Dry	Dry, 1:99...99:1, Wet
	Table , “Sets the balance between the effect and dry sounds,” on page 175
j	Src		Off...Tempo
	Table , “Selects the modulation source of the effect balance,” on page 175
	Amt		–100...+100
	Table , “Sets the modulation amount of the effect bal-
	ance,” on page 175