Command Reference
Table
|
|
| |
Command | Description |
| |
FOLD? | Asks for the supply’s present foldback setting. | ||
| R ponse: FOLD <mode> where mode is: | ||
| 0 (OFF) or |
|
|
| 1 (CV or Co | stant Voltage mode) or | |
| 2 (CC or Co | stant Current mode) | |
GTL | Go to local. Returns the power supply to local control. See LLO (Local Lockout). | ||
| S e also“Remote/Local Operation” on page | ||
HOLD <1/ON>, | Enables or disables voltage/current setting hold mode for the supply. When | ||
<0/OFF> | HOLD ON is specified, hold mode is enabled so that all voltage and current | ||
| settings which would normally be implemented by the supply are held until a TRG | ||
| (trigger) c | mmand is received. This feature allows you to synchronize the | |
| operat | f several supplies. | |
| Initial value: HOLD OFF or HOLD 0 | ||
|
| ||
HOLD? | Asks for the present hold mode setting. | ||
| R ponse: HOLD 0 (OFF or disabled) or HOLD 1 (ON or enabled) | ||
|
| ||
ID? | Asks for the power supply model and the master EPROM version. | ||
| R ponse: ID <model name><version> | ||
|
| ||
IDATA | Calculates and records the slope and offset for programmed current using ILO and | ||
<Ilo>,<Ihi> | IHI data. Set CMODE ON before using this command. See also the calibration | ||
| procedures in Chapter 4. | ||
| <Ilo> and <Ihi> are in <current> format. | ||
|
| ||
IHI | In response to this command, the power supply sends a programmed current value | ||
| to the output terminal. This value is at the high end of the power supply’s current | ||
| range and is read by an external device connected as part of the calibration | ||
| procedure. Refer to this value as IHI and record it to use as input with the IDATA | ||
| command. Set CMODE ON before using this command. See also the calibration | ||
| procedures in Chapter 4. | ||
|
| ||
ILO | In response to this command, the power supply sends a programmed current value | ||
| to the output terminal. This value is at the low end of the power supply’s current | ||
| range and is read by an external device connected as part of the calibration | ||
procedure. Refer to this value as ILO and record it to use as input with the IDATA command. Set CMODE ON before using this command. See also the calibration procedures in Chapter 4 .
