Xantrex Technology ENET-XFR3 manual 2Ethernet/RS-232 Interface Jumper Selections, Xoff

			Initial Inspection
Table 2-2Ethernet/RS-232 Interface Jumper Selections
J2JUMPER	SELECTIONBaud rate selection	page 2–18	B1 (5-6) [closed] [default]
	(default 9600)		B2 (3-4) [closed] [default]
			B3 (1-2) [closed] [default]
J2	RS-232 flow control	page 2–19	FLW (7-8) [closed] [default] Flow control disabled.
	selection hardware (RTS/		FLW (7-8) [open] Flow control enabled.
	CTS) or software (XON/		XON (9-10) [closed] [default] Hardware flow control.
	XOFF)		XON (9-10) [open] Software flow control.
J2	Unused		(11-12) [closed] [default] Provides extra jumper.
			(13-14) [open] Not used.
J2	Power-On remote/local	page 2–20	PONREM (15-16) [open] [default] PON in remote.
			PONREM (15-16) [closed] PON in local.
J3, J4,	Ethernet or RS232 mode	page 2–12	(2-3) [default] Ethernet.
J5, J6			(1-2) RS232.
J65	Local OVP control	page 2–24	[closed] [default]
	selection		[open] Front Panel OVP Control.
J93	User TTL shutdown (S/D)	page 2–25	(1-2) User TTL S/D line active low.
	selection		(2-3) [default] User TTL S/D line active high.
J103	Remote OVP control	page 2–24	[closed] [default]
	selection		[open]

Note: All other jumpers are not user-selectable.

LEDCR89INDICATORSRed Diagnostic LED Bus error or Soft restart on Master circuitry

CR166 Red Diagnostic LED Soft restart on Master circuitry

CR167 Green Diagnostic LED Bus error on Master circuitry

Refer to “Troubleshooting” on page 3–20for more information on these LEDs.

EPROMSSlave EPROM See revision number stamped on EPROM

Master EPROM See revision number stamped on EPROM

TM-XR9B-01XN 2–7