Xantrex Technology ENET-XFR3 User Lines Cable Connection, 7User Lines Cable with Ferrite Block

Installation and Configuration

User Lines Cable Connection

Use a standard 8-position telephone jack and data cable to connect to the user line connector. Add a ferrite block to reduce radiated emission. The one inch square ferrite block with built-in housing clip is packaged and shipped with the power supply interface card.

To install the ferrite block:

1.Position the block no more than 5 cm (2 in.) from the power supply end of the user line connector cable.

2.Open the ferrite block housing.

3.Loop the cable through the ferrite block. See Figure 2-7, “User Lines Cable with Ferrite Block” on page 2–28.

4.Close the housing clip.

The ferrite block ensures that the power supply system meets radiated emission requirement 89/336/EEC for CE mark approval. See the power supply's operating manual for noise specifications.

User Lines Cable

Ferrite Block

To Connector on XFR

To User Custom Interface

Figure 2-7User Lines Cable with Ferrite Block

2–28 TM-XR9B-01XN