Command Summary
Table 3-4 Query Commands
AUXA?Command | DescriptionAsks for the state of the set value for the AUXA command |
AUXB? | Asks for the state of the set value for the AUXB command |
|
|
CMODE? | Asks for the power supply’s calibration mode status. |
|
|
DLY? | Asks for the programmable time delay setting before the supply |
| reports fault conditions. |
|
|
ERR? | Asks for the most recent remote programming error which |
| occurred in the supply since the last time the error query |
| command (ERR?) was used. |
|
|
FOLD? | Asks for the supply’s present foldback setting. |
|
|
HOLD? | Asks for the present hold mode setting. |
|
|
ID? | Asks for the power supply’s model name and master EPROM |
| version. |
|
|
IMAX? | Asks for the supply’s soft current limit setting. |
|
|
IOUT? | Measures the supply’s actual current output. |
|
|
ISET? | Asks for the supply’s present output current limit setting. |
|
|
OUT? | Asks for the present enabled/disabled status of the supply’s |
| output. |
|
|
OVSET? | Asks for the supply’s present over voltage protection limit. |
|
|
REN? | Asks for the state of remote enable. |
|
|
ROM? | Asks for the version number of the master and slave EPROMs on |
| the interface PCB. |
|
|
VMAX? | Asks for the supply’s soft voltage limit setting. |
|
|
VOUT? | Measures the supply’s actual voltage output. |
|
|
VSET? | Asks for the supply’s present output voltage setting. |
|
|
