Xantrex Technology RS2000 manual System Accessories and Network Components, 5System Accessories

Introduction

System Accessories and Network Components

System accessories can be used with the RS2000 in a Xanbus system. The System Control Panel (SCP) provides configuration and monitoring capability for Xanbus-enabled devices such as the RS2000. Automatic Generator Start (AGS) automatically starts and stops your generator. It continuously monitors your battery system and thermostats and starts the generator if the battery state of charge or the voltage reaches preset limits, or the air conditioner or heater needs to be run.

Table 1-5 provides the part numbers for the system accessories.

Table 1-5System Accessories

Accessory	Part number
System Control Panel (SCP)	809-0910
Automatic Generator Start (AGS)	809-0915

Consult with your local system designer to determine what network components will be needed for your specific installation. Table 1-6provides a list of network components and part numbers. Pre-made cables are available in standard lengths ranging from 3 feet to 75 feet.

Table 1-6Network Components and Part Numbers

Network Component	Part Number
Network termination — Male (2 per pack)	809-0901
3-way network connector	809-0903
Network termination — Female (2 per pack)	809-0905
Network cable 3 ft. (0.9 m)	809-0935
Network cable 5 feet (1.5 m)	809-0936
Network cable 7 feet (2.0 m)	809-0937
Network cable 10 feet (3.0 m)	809-0938
Network cable 14 feet (4.3 m)	809-0939
Network cable 25 feet (7.6 m)	809-0940
Network cable 50 feet (15.2 m)	809-0941
Network cable 75 feet (22.9 m)	809-0942

These accessories and network components are available from any authorized Xantrex dealer or at www.xantrex.com. Detailed information on planning and installing your network is available in the Xanbus System Installation Guide. This guide is available for downloading at

www.xantrex.com

1–12 975-0125-01-01