Xantrex Technology RS2000 manual Operating Limits for Inverter Operation, Power Output

	Operation
Operating Limits for Inverter Operation
Power Output
Temperature	The continuous output rating for the RS2000 is 2000 watts or 17 amps at
	120 volts AC. The RS2000 can deliver this power in an ambient
	(surrounding) temperature up to 122 °F (50 °C). Above this temperature,
	you must reduce the power demand or the unit may shut down to protect
	itself against overheating.
	As with all inverters, the amount of continuous power that the RS2000
	can deliver without overheating is limited by the ambient air temperature.
	The RS2000 will operate and deliver its continuous power rating at higher
	temperatures, but the ambient temperature as well as the input voltage
	from the battery will limit the extent to which it can run continuously.
	Operating the inverter/charger in conditions outside of power and
	temperature limits will result in thermal shutdown and/or significantly
	decreased performance. In addition, operation in this range is outside the
	ratings covered by the regulatory approvals of the product. See “Invert
	Power Derating vs Ambient Temperature” on page A–6.
Difficulty on	The inverter/charger should be able to operate all AC loads rated at or
starting loads	below its power rating. Some high horsepower induction motors used in

pumps and other motor-operated equipment require very high surge currents to start, and the inverter/charger may have difficulty starting these loads. See “Inverter Applications” on page 4–17.

If you have problems starting certain loads, ensure that:

• the battery connections are tight and clean

• the DC cabling is no longer than the recommended length. Refer to the RS2000 Sine Wave Inverter/Charger Installation Guide for this information.

• the AC wiring is of recommended size. Refer to the RS2000 Sine Wave Inverter/Charger Installation Guide for this information.

• the battery is of sufficient capacity and is fully charged.

975-0125-01-01 2–13