Xantrex Technology RS2000 manual 10 9

Introduction

5	4	3				7
			2	1	6		11	12

10 9 8 13

Figure 1-3Front Panel Lights and Buttons

Table 1-2	Description of Front Panel Lights and Buttons
Feature	Description
1	External AC light illuminates when you are connected to an AC source like the utility grid or
	a generator and the AC is qualified.
2	Inverter ON light illuminates when the RS2000 is operating in invert mode.
3	Low Battery light illuminates when the battery voltage is low.
4	Network light illuminates when there is activity on the network.
5	Fault light illuminates if a fault condition occurs.
6	Charger ON light illuminates when the RS2000 is in charge mode and is producing DC output
	to charge your batteries.
7	Bulk light illuminates when the charger is in the bulk stage of battery charging.
8	Absorption light illuminates when the charger is in the absorption stage of battery charging.
9	Float light illuminates when the charger is in the float stage of battery charging.
10	Equalize light illuminates when the unit is equalizing the batteries.

11Charger Enable button toggles between enable (On) and disable (Off). When the charger is enabled, it can produce DC output to charge your batteries. When the charger is disabled, it does not produce DC output to charge your batteries, but still passes AC input through to AC loads (if present).

12Inverter Enable button toggles between enable (On) and disable (Off). When the inverter is enabled, it can produce AC output to run your AC loads. When the inverter is disabled, it does not produce AC output to run your loads; however, if qualified AC is present, the unit passes AC through to AC loads.

13Reset button is used for several functions: to reset after a fault, to perform a power on reset, to wake the RS2000 from Power Save mode or Hibernate mode. See “System Modes” on page 2– 6 for a description of the different modes.

1–8 975-0125-01-01