Xantrex Technology RS2000 manual Table A-2Charger Specifications

Specifications

Charger Specifications

All charging specifications are at nominal conditions: ambient temperature of 77 °F (25 °C), 120 VAC, 60 Hz input, unless otherwise specified.

Table A-2Charger Specifications

Charging method	• Three-stage charge (Bulk, Absorption, Float)
	• Two-stage charge (Bulk, Absorption)
	The default charging method is three-stage.
Without a battery temperature	Three settings with the following temperature
sensor	values:
	• Cool 50 °F (10 °C)
	• Warm 77 °F (25 °C)
	• Hot 104 °F (40 °C)
	The default value for this setting is Hot, and it can
	only be changed by a dealer, factory, or service
	centre.
With a battery temperature	The temperature compensation coefficients on a
sensor	12 volt battery are as follows:
	• Flooded: 27 mV × (25 °C – BTS °C)
	• Gel: 27 mV × (25 °C – BTS °C)
	• AGM: 21 mV × (25 °C – BTS °C)
Equalization cycle	Yes, manual via System Control Panel
Number of independent battery	1
banks
Battery bank size settings	50 – 2000 Ahr
Battery type settings	Flooded, AGM, Gel, Custom
Power factor corrected charging	Yes
AC input voltage	90 – 135 VAC
AC input frequency	60 Hz nominal, 55 – 65 Hz operating range
Minimum battery voltage	3.0 VDC
Maximum DC output voltage	16.0 VDC
Charger efficiency	≥ 85%
Input power factor at full	> 0.95
charge rate
Maximum charge current	100 A

975-0125-01-01 A–3