Xerox 2060 manual Table F-4.JES3 initialization dataset commands example

Defining the printer to the host: TCP/IP attachment

Table F-3. JES3 FSS statement parameters (Continued)

			Range of
Item		Source of	acceptable		Your
description	Default	value	values	Comments	value
WC	Any class	Installation	List of	If CLASS is specified in
	selected	output class	alphanumeric	the Work-selection
		standards	output classes,	criterion in the WS
			each separated	parameter, the FSA
			by a comma	selects datasets that
				match values specified
				here.
WS		Installation	Work-selection	Consider CL, R, and F.
		preferences	criterion	See Note below and
		(see note)		JES3 Initialization and
				Tuning Reference
				manual for more
				information.

NOTE: The WS parameter CL specifies that datasets with the same class as the WS parameter should be selected. D specifies that only datasets with the same destination as the DGROUP parameter should be selected. F specifies that JES3 is to pass the forms value specified on the DD or OUTPUT JCL statement to the FSA.

Following is an example of the JES3 initialization dataset required commands:

Table F-4.JES3 initialization dataset commands example

FSSDEF TYPE=WTR,FSSNAME=FSSTCP1,PNAME=FSSPROC1,SYSTEM=SYS1,TERM=NO

DEVICE DTYPE=PRTAFT1,JNAME=PRT7,JUNIT=(,SYS1,,OFF),FSSNAME=FSSTCP1,

DGROUP=LOCAK, MODE=FSS,PM=(LINE,PAGE,SOSI1),WC=(T),WS=CL,D,F)

F-8 Installation Planning Guide