Controller specifications and requirements

WARNING

To reduce the risk of electrical shock, do not plug components into any other type of power system. Contract your facilities manager or a qualified electrician if you are not sure what type of power is supplied to your work area.

Environmental specifications

The environmental requirements for the DocuColor NPS/IPS controller are all satisfied by the printer module. Refer to the “Printer specifications and requirements” chapter of this guide.

The heat dissipation for the printer controller (processor and monitor) is 1,100 BTU per hour.

Space requirements

This section provides recommendations for placement of printer controller hardware components.

For printer component space requirements, refer to the “Printer specifications and requirements” chapter of this guide. Contact your service representative if you have questions not specifically addressed in this guide.

Printer controller placement

You should consider the following factors when deciding where to place the DocuColor printer controller:

Adequate work space and service clearance around the equipment

Proximity to electrical and network connectors

Security of the work area. You may need to place the system in an area where you can restrict access to it.

You must supply a table or desk as a work surface for the printer controller, and the PCI board if this is part of the system configuration. The top of the table must provide at least 36 by 36 inches / 91 by 91 cm of space for each component, to allow enough space for the components and cables, as well as for service access.

Installation Planning Guide

5-3

Page 81
Image 81
Xerox 2060 manual Environmental specifications, Space requirements, Printer controller placement