Defining the printer to the host: TCP/IP attachment
Installation Planning Guide F-23
2. Create the PSF/400 configuration
Follow these steps to configure PSF/400 for the printer.
1. At the AS/400, press <F4> to prompt the CRTPSFCFG
command.
2. Key in the parameter values as indicated in the figure below.
For parameters with * beside them, refer to the configuration
worksheet, earlier in this section.
Table F-15. Create PSF Configuration screen – AS/400
Create PSF Configuration (CRTPSFCFG)
Type choices, press Enter.
PSF configuration......... > XEROXIPS *
Library................. > QGPL
User resource library list. *JOBLIBL
Device resource library list....
+ for more values *DFT
IIPDS pass through....... *NO
Activate release time..... *NORDYF
Release time............. > *SEC30 or
*NOMAX
Restart timer............ > *IMMED
SNA retry count.......... 10
Delay time between SNA retries.. 90
Text ‘description’........ *BLANK
Additional parameters....
Blank page............... *YES
Page size control........ *NO
Resident font............ *NO
Resource retention....... *Y ES
Edge orient.............. *NO
Remote location:
Name or address........ > ‘9.9.9 99.999’ *
TCP/IP port.............. > 5001 *
TCP/IP activation timer... 170