SETTING UP WORKSTATIONS

Setting up Macintosh workstations

This section describes the steps for installing the Xerox Document

Submission Client Software and the appropriate PPD (PostScript

Printer Description) file.

Preparing for Installation

Before installing the software, make sure your computer has the following hardware and software:

2 MB of Random Access Memory (RAM)

A properly configured network card, or a bridge from localTalk to the network

A3.5-inch, 1.4-MB diskette drive A hard drive

AppleShare version 2.0 or above System 7.0 or greater EtherTalk, version 1.0 or above

Ethernet software that is associated with your Ethernet card

Apple LaserWriter Driver, version 7.11 or higher. Version 8.0 or higher is recommended for use with PPD files, since earlier version do not recognize PPD files.

Note: You cannot run the print job submission utility if you have the QuickDraw GX environment installed.

GUIDE TO SUBMITTING JOBS FROM THE CLIENT

2-7

Page 27
Image 27
Xerox 721P87481 manual Setting up Macintosh workstations, Preparing for Installation