Flash Memory

Flash Memory

Flash Memory

Flash memory can be used to store downloaded fonts, macros, symbol sets, logos, and forms.

You can install one flash memory SIMM in your printer.

Flash memory SIMMs are available in 1, 2, and 4MB.

Data stored in flash memory is retained when the printer is powered off.

Accessing the System Board from the Rear

To install a flash memory SIMM, you need to access the printer system board on the back of the printer. Follow these steps to access the board:

1

2

3

4

Turn the printer so its back is facing you.

Unplug the printer power cord.

Disconnect all cables from the back of the printer.

Do one of the following:

Remove the optional Tray 2, if one is installed. If you need help, see the documentation that came with it.

Remove the printer rear cover. Press down on the two tabs located at the top of the rear cover, and pull the cover away from the printer.

Appendix C: Printer Options C-9

Page 139
Image 139
Xerox NC20 manual Flash Memory, Accessing the System Board from the Rear