Chapter 8 VLAN
Figure 42 Port Based VLAN Setup (Port Isolation)
The following table describes the labels in this screen.
Table 19 Port Based VLAN Setup
label | Description |
Setting Wizard | Choose All connected or Port isolation. |
| All connected means all ports can communicate with each other, that is, there are no |
| virtual LANs. All incoming and outgoing ports are selected. This option is the most |
| flexible but also the least secure. |
| Port isolation means that each port can only communicate with the CPU |
| management port and cannot communicate with each other. All incoming ports are |
| selected while only the CPU outgoing port is selected. This option is the most limiting |
| but also the most secure. |
| After you make your selection, click Apply (top right of screen) to display the screens |
| as mentioned above. You can still customize these settings by adding/deleting |
| incoming or outgoing ports, but you must also click Apply at the bottom of the screen. |
|
|
Incoming | These are the ingress ports; an ingress port is an incoming port, that is, a port through |
| which a data packet enters. If you wish to allow two subscriber ports to talk to each |
| other, you must define the ingress port for both ports. The numbers in the top row |
| denote the incoming port for the corresponding port listed on the left (its outgoing |
| port). CPU refers to the Switch management port. By default it forms a VLAN with all |
| Ethernet ports. If it does not form a VLAN with a particular port then the Switch cannot |
| be managed from that port. |
|
|
102 |
| |
| ||
|
|
|