Chapter 47 Configuration Mode Commands
•Enable STP on port 5 with a path cost of 150.
•Set the priority for port 5 to 20.
sysname(config)#
sysname(config)#
sysname(config)#
47.5 no Command Examples
These are the commonly used command examples that belong to the no group of commands. The no group commands are commands which are preceded by keyword no. This command negates the intended action of the command. In most cases the no command disables, resets or clears settings. There are cases, however, where the no command can activate features. This section shows some uses of these commands.
47.5.1 Disable Commands
Use the no command to disable features on the Switch.
Syntax:
no
Disables STP on the Switch.
Disables port mirroring on the Switch.
47.5.2 Resetting Commands
Use the no command to reset Switch settings to their default values.
Syntax:
no https timeout
Resets the https session timeout to default.
An example is shown next. The session timeout is reset to 300 seconds.
sysname(config)# no https timeout Cache timeout 300
47.5.3 Re-enable commands
The no command can also be used to
no ip route <ip> <mask> inactive
| 387 |
|
|