48
Interface Commands
These are some commonly used configuration commands that belong to the interface group of commands.
48.1 Overview
The interface commands allow you to configure the Switch on a port by port basis.
48.2 Interface Command Examples
This section provides examples of some frequently used interface commands.
48.2.1 interface port-channel
Use this command to enable the specified ports for configuration. Indicate multiple, nonsequential ports separated by a comma. Use a dash to specify a port range.
Syntax:
interface
An example is shown next.
•Enter the configuration mode.
•Enable ports 1, 3, 4 and 5 for configuration.
•Begin configuring for those ports.
sysname# config
sysname(config)# interface
48.2.2 bpdu-control
Syntax:
| 395 |
|
|