Chapter 49 IEEE 802.1Q Tagged VLAN Commands
49.2 Global VLAN1Q Tagged VLAN Configuration Commands
This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.
49.2.1 GARP Status
Syntax:
show garp
This command shows the Switch’s GARP timer settings, including the join, leave and leave all timers.
An example is shown next.
sysname# show garp GARP Timer
Join Timer = 200
Leave Timer = 600 Leave All Timer = 10000 sysname#
49.2.2 GARP Timer
Syntax:
garp join <msec> leave <msec> leaveall <msec>
where
join <msec> | = | This sets the duration of the Join Period timer for GVRP in |
|
| milliseconds. Each port has a Join Period timer. The allowed Join Time |
|
| range is between 100 and 32767 milliseconds; the default is 200 |
|
| milliseconds. |
leave <msec> | = | This sets the duration of the Leave Period timer for GVRP in |
|
| milliseconds. Each port has a single Leave Period timer. Leave Time |
|
| must be two times larger than Join Timer; the default is 600 |
|
| milliseconds. |
leaveall <msec>
=This sets the duration of the Leave All Period timer for GVRP in milliseconds. Each port has a single Leave All Period timer. Leave All Timer must be larger than Leave Timer; the default is 10000 milliseconds.
This command sets the Switch’s GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP timers set declaration timeout values.
404 |
| |
| ||
|
|
|