Chapter 11 Spanning Tree Protocol
Figure 50 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the Switch. This screen is described in detail in the section that follows the configuration section for each STP mode. Click Configuration to activate one of the STP standards on the Switch.
11.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch. Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 51 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 24 Advanced Application > Spanning Tree Protocol > Configuration
LABEL | DESCRIPTION |
Spanning Tree | You can activate one of the STP modes on the Switch. |
Mode | Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple |
| Spanning Tree. See Section 11.1 on page 109 for background information on |
| STP. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| loses these changes if it is turned off or loses power, so use the Save link on the |
| top navigation panel to save your changes to the |
| are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
| 115 |
|
|