ZyXEL Communications GS-4012 8.7 Configuring Subnet Based VLAN

Chapter 8 VLAN

Click Subnet Based VLAN in the VLAN Port Setting screen to display the configuration screen as shown.

"Subnet based VLAN applies to un-tagged packets and is applicable only when you use IEEE 802.1Q tagged VLAN.

Figure 40 Advanced Application > VLAN > VLAN Port Setting > Subnet Based VLAN

The following table describes the labels in this screen.

Table 18 Advanced Application > VLAN > VLAN Port Setting > Subnet Based VLAN Setup

LABEL	DESCRIPTION
Active	Check this box to activate this subnet based VLANs on the Switch.

DHCP-Vlan	When DHCP snooping is enabled DHCP clients can renew their IP address through
Override	the DHCP VLAN or via another DHCP server on the subnet based VLAN.
	Select this checkbox to force the DHCP clients in this IP subnet to obtain their IP
	addresses through the DHCP VLAN.

Apply	Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
	these changes if it is turned off or loses power, so use the Save link on the top
	navigation panel to save your changes to the non-volatile memory when you are done
	configuring.

Active	Check this box to activate the IP subnet VLAN you are creating or editing.

Name	Enter up to 32 alpha numeric characters to identify this subnet based VLAN.

IP	Enter the IP address of the subnet for which you want to configure this subnet based
	VLAN.