50

Multicast VLAN Registration Commands

This chapter shows you how to use Multicast VLAN Registration (mvr) commands.

50.1 Overview

Use the mvr commands in the configuration mode to create and configure multicast VLANs.

"If you want to enable IGMP snooping see Section 47.2 on page 383.

50.2Create Multicast VLAN

Use the following commands in the config-mvr mode to configure a multicast VLAN group. Syntax:

mvr <vlan-id>

mvr <vlan-id> source-port <port-list> mvr <vlan-id> receiver-port <port-list> mvr <vlan-id> inactive

mvr <vlan-id> mode <dynamiccompatible> mvr <vlan-id> name <name-str>

mvr <vlan-id> tagged <port-list>

mvr <vlan-id> group <name-str> start-address <ip> end-address <ip> mvr <vlan-id> exit

where

<vlan-id>

source-port <port-list>

receiver-port <port-list>

name <name-str>

=The VLAN ID [1 – 4094].

=Specifies the MVR source ports which send and receive multicast traffic.

=Specifies the MVR receiving ports which only receive multicast traffic.

=A name to identify the multicast VLAN group.

 

411

GS-4012F/4024 User’s Guide