Chapter 26 Static Route
Table 81 Static Routing (continued)
LABEL | DESCRIPTION |
Metric | The metric represents the “cost” of transmission for routing purposes. IP routing uses |
| hop count as the measurement of cost, with a minimum of 1 for directly connected |
| networks. Enter a number that approximates the cost for this link. The number need |
| not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good |
| number. |
|
|
Add | Click Add to insert a new static route to the Switch’s |
| loses these changes if it is turned off or loses power, so use the Save link on the top |
| navigation panel to save your changes to the |
| done configuring. |
|
|
Cancel | Click Cancel to reset the above fields to your previous configuration. |
|
|
Clear | Click Clear to set the above fields back to the factory defaults. |
|
|
Index | This field displays the index number of the route. Click a number to edit the static |
| route entry. |
|
|
Active | This field displays Yes when the static route is activated and NO when it is |
| deactivated. |
|
|
Name | This field displays the descriptive name for this route. This is for identification purpose |
| only. |
|
|
Destination | This field displays the IP network address of the final destination. |
Address |
|
|
|
Subnet Mask | This field displays the subnet mask for this destination. |
|
|
Gateway | This field displays the IP address of the gateway. The gateway is an immediate |
Address | neighbor of your Switch that will forward the packet to the destination. |
|
|
Metric | This field displays the cost of transmission for routing purposes. |
|
|
Delete | Click Delete to remove the selected entry from the summary table. |
|
|
Cancel | Click Cancel to clear the Delete check boxes. |
|
|
226 |
| |
| ||
|
|
|