47
Configuration Mode Commands
This chapter describes how to enable and configure your Switch’s features using commands. For more background information, see the feature specific chapters which proceed the commands chapters.
47.1 Change the Out of Band Management IP Address
Use the ip address command to change the IP address of the out of band management port on the Switch.
Syntax:
ip address <IP Adress> <Subnet Mask>
An example is shown next.
•Change the out of band Management IP address to 192.168.0.2
•View updated settings.
sysname(config)# ip address 192.168.0.2 255.255.255.0 sysname(config)# exit
sysname# show ip Management IP Address
IP[192.168.0.2], Netmask[255.255.255.0], VID[0] IP Interface
IP[192.168.2.1], Netmask[255.255.255.0], VID[2]
See example in Section 48.2 on page 395 for information on how to change the in band management IP address for the Switch.
47.2 Enabling IGMP Snooping
To enable IGMP snooping on the Switch. Enter
| 383 |
|
|